Hallo
Zu meiner Person, ich heiße Frank bin 41 Jahre und komme aus dem Raum Bingen am Rhein.
Mein Problem, das wohl jeder Anfänger hat, sind die Motoren. Die machen keinen Mucks.
Folgende Komponenten sind verbaut:
4x Suppo 2212 Motoren
4x Modelcraft Regler 20 A
FC MultiWii SE 2.0 Crius
MultiWii 2.2 aufgespielt
Empfänger Spektrum AR 500
Regler sind angelernt und die Combos funktionieren einwandfrei direkt am Empfänger.
Sobald alles am FC ist, ist es vorbei. Motoren piepsen 3 mal.
Scharfschalten ist auch nicht.
In der MINCOMMAND habe ich einige Werte versucht, erfolglos.
Im MultiWii Configtool werden aber alle Steuerbefehle korrekt angezeigt.
/**************************** Motor minthrottle *******************************/
/* Set the minimum throttle command sent to the ESC (Electronic Speed Controller)
This is the minimum value that allow motors to run at a idle speed */
//#define MINTHROTTLE 1300 // for Turnigy Plush ESCs 10A
//#define MINTHROTTLE 1120 // for Super Simple ESCs 10A
//#define MINTHROTTLE 1064 // special ESC (simonk)
//#define MINTHROTTLE 1050 // for brushed ESCs like ladybird
#define MINTHROTTLE 1050
// (*)
/**************************** Motor maxthrottle *******************************/
/* this is the maximum value for the ESCs at full power, this value can be increased up to 2000 */
#define MAXTHROTTLE 1850
/**************************** Mincommand *******************************/
/* this is the value for the ESCs when they are not armed
in some cases, this value must be lowered down to 900 for some specific ESCs, otherwise they failed to initiate */
#define MINCOMMAND 960
/********************************** I2C speed ************************************/
#define I2C_SPEED 100000L //100kHz normal mode, this value must be used for a genuine WMP
//#define I2C_SPEED 400000L //400kHz fast mode, it works only with some WMP clones
/*************************** Internal i2c Pullups ********************************/
/* enable internal I2C pull ups (in most cases it is better to use external pullups) */
#define INTERNAL_I2C_PULLUPS